2 files changed, 4 insertions, 4 deletions

diff --git a/www/mods/disassemble.t b/www/mods/disassemble.t
index 7b50f18bca..e5941bd2ee 100644
--- a/www/mods/disassemble.t
+++ b/www/mods/disassemble.t
@@ -20,10 +20,10 @@ Use your thumb nails to compress the thin edge of the rubber while gently pullin
 Do the same on the side.
 <hr>
 
-<p><img src="b9.jpg">
+<p><img src="b9.jpg"> <img src="b11.jpg">
 <br>
-You have liberated one end of the Archos from the metal back plate!
-Now lightly lift the blue rubber bumbers up from the circuit board on the other end, then slide the Archos out of the back plate.
+You have now freed one end of the Archos.
+Now lift the blue rubber bumbers up from the circuit board on the other end, and simply slide the Archos out of its' back plate.
 
 <p><i>Björn</i>
 
diff --git a/www/mods/rs232.t b/www/mods/rs232.t
index 952922e4da..6abcea310b 100644
--- a/www/mods/rs232.t
+++ b/www/mods/rs232.t
@@ -12,7 +12,7 @@ It takes its power from the DTR signal in the serial port, so the communication
 
 <h2>How to power it the safe way</h2>
 <p>
-It is also possible to take power from the USB port, or another 5-10V source. Just remove the D1 diode and connect the power to the +5V and GND pads.
+If your PC is a laptop or otherwise might risk having too little power in the serial port, it is also possible to take power from the USB port or another 5-10V source. Just remove the D1 diode and connect the power to the +5V and GND pads.
 
 <h2>How to make one</h2>