1 files changed, 6 insertions, 6 deletions

diff --git a/manual/configure_rockbox/recording_settings.tex b/manual/configure_rockbox/recording_settings.tex
index 036450accd..ab39ea54c5 100644
--- a/manual/configure_rockbox/recording_settings.tex
+++ b/manual/configure_rockbox/recording_settings.tex
@@ -51,7 +51,7 @@
         22.05kHz, 16kHz, 12kHz, 11.025kHz and 8kHz}
     are available. Higher sample rates use up more disk space, but give better
     sound quality.
-    \opt{swcodec}{\note{The 11.025kHz setting is not available when using%
+    \opt{swcodec}{\note{The 11.025kHz setting is not available when using %
       \setting{MPEG Layer 3} format.}
     }%
     \opt{masf}{
@@ -170,11 +170,11 @@
         
   \item[Prerecord Time.]
     This specifies the time that is included into the recording before the
-        trigger event occurs. This is very useful if you record a signal that fades
-        in. Usually you want to set the prerecord time >= start duration. That
-        ensures that you record the entire sound. Strictly speaking the prerecord
-        time is not a special parameter of the trigger. It is available during normal
-        recordings too.  
+        trigger event occurs. This is very useful if you record a signal that
+       fades in. Usually you want to set the prerecord time greater than or
+        equal to the start duration. That ensures that you record the entire
+        sound. Strictly speaking the prerecord time is not a special parameter
+        of the trigger. It is available during normal recordings too.
         
   \item[Start Above.]
         The start threshold defines the minimal volume a sound must have to start the