From e8c72b68917b064c6ec7b87d46b4ee59faea7ffb Mon Sep 17 00:00:00 2001 From: Alexander Levin Date: Sun, 9 May 2010 18:33:31 +0000 Subject: Use typographic quotation marks -- correct more places git-svn-id: svn://svn.rockbox.org/rockbox/trunk@25917 a1c6a512-1295-4272-9138-f99709370657 --- manual/configure_rockbox/recording_settings.tex | 4 ++-- manual/configure_rockbox/sound_settings.tex | 2 +- 2 files changed, 3 insertions(+), 3 deletions(-) (limited to 'manual/configure_rockbox') diff --git a/manual/configure_rockbox/recording_settings.tex b/manual/configure_rockbox/recording_settings.tex index 78befa623f..3ab3966b70 100644 --- a/manual/configure_rockbox/recording_settings.tex +++ b/manual/configure_rockbox/recording_settings.tex @@ -193,7 +193,7 @@ \item[Start Above.] The start threshold defines the minimal volume a sound must have to start the - recording. It is displayed numerically in the line "Start Above". Note that + recording. It is displayed numerically in the line ``Start Above''. Note that the unit of the threshold depends on the settings of the peak meter. (i.e. When the peak meter displays dB you can adjust the level in dB and when the peak meter is set to linear the threshold is displayed as percentage.) In the @@ -216,7 +216,7 @@ \item[Stop Below.] When the sound level drops below the stop threshold the recording is stopped. - It is displayed numerically in the line "Stop Below". Just like the start + It is displayed numerically in the line ``Stop Below''. Just like the start threshold the unit of the stop threshold depends on the settings of the peak meter. There's also a small triangular marker in the peak meter at the bottom of the screen. In contrast to the start threshold marker it points to the diff --git a/manual/configure_rockbox/sound_settings.tex b/manual/configure_rockbox/sound_settings.tex index 61b450e761..4828826366 100644 --- a/manual/configure_rockbox/sound_settings.tex +++ b/manual/configure_rockbox/sound_settings.tex @@ -497,6 +497,6 @@ The \setting{Release Time} setting sets the recovery time after the signal is compressed. Once the compressor determines that compression is necessary, the input signal is reduced appropriately, but the gain isn't allowed to immediately return to normal levels. This is necessary to reduce artifacts -such as "pumping." Instead, the gain is allowed to return to normal at the +such as ``pumping.'' Instead, the gain is allowed to return to normal at the chosen rate. Release Time is the time for the gain to recover by 10~dB. } -- cgit v1.2.3