From dcd71e66bd5f0b521c9f98ebe83ff1f7abb62918 Mon Sep 17 00:00:00 2001 From: William Wilgus Date: Thu, 14 Dec 2017 06:22:04 +0100 Subject: Optimize lcd-ssd1303 driver (clip series) Saves 100+ bytes (50 of it in iram), saves a bit of power Internal LCD clock decreased but with added efficiency of drawing routines loses only around 2 Hz on the scanrate (~75Hz) while fps is slightly increased Column offsets are now calculated outside the loops saving a few instructions Passing a LCD_NOP command after lcd_update turns off Data/Cmd# gpio saving a bit more power Added a function lcd_write_cmd_triple() that allows 3 commands to be sent at once when enabled with LCD_USE_FIFO_FOR_COMMANDS it sends them back to back without checking FIFO status in between or sending to thhe D/C# Gpio. Makes an assumption about the FIFO being large enough to accept 3 commands after being emptied which should be the case on the clipv1, clipv2, clipplus. I have only enabled it for the clip plus as thats the only device I have to test it on. On clip+ the SSP clock is now turned off when screen is off Change-Id: Ib5fd24697bfe4ac8b8ee017361e789e4a7910d21 --- .../target/arm/as3525/sansa-clipv2/lcd-clipv2.c | 29 ++++++++++++++++++++++ 1 file changed, 29 insertions(+) (limited to 'firmware/target/arm/as3525/sansa-clipv2/lcd-clipv2.c') diff --git a/firmware/target/arm/as3525/sansa-clipv2/lcd-clipv2.c b/firmware/target/arm/as3525/sansa-clipv2/lcd-clipv2.c index d7266f72a0..0b3317255a 100644 --- a/firmware/target/arm/as3525/sansa-clipv2/lcd-clipv2.c +++ b/firmware/target/arm/as3525/sansa-clipv2/lcd-clipv2.c @@ -63,6 +63,35 @@ void lcd_write_command(int byte) DBOP_TIMPOL_23 = 0xE037E037; } +void lcd_write_cmd_triplet(int cmd1, int cmd2, int cmd3) +{ +#ifndef LCD_USE_FIFO_FOR_COMMANDS + lcd_write_command(cmd1); + lcd_write_command(cmd2); + lcd_write_command(cmd3); +#else + /* combine writes to data register */ + + while ((DBOP_STAT & (1<<10)) == 0) /* While push fifo is not empty */ + ; + /* FIFO is empty at this point */ + /* unset D/C# (data or command) */ + GPIOB_PIN(2) = 0; + DBOP_TIMPOL_23 = 0xE0370036; + + /* Write command */ + /* !!makes assumption FIFO is at least (3) levels deep! */ + DBOP_DOUT8 = cmd1; + DBOP_DOUT8 = cmd2; + DBOP_DOUT8 = cmd3; + /* While push fifo is not empty */ + while ((DBOP_STAT & (1<<10)) == 0) + ; + + DBOP_TIMPOL_23 = 0xE037E037; +#endif +} + void lcd_write_data(const fb_data* p_bytes, int count) { volatile int i = 0; -- cgit v1.2.3