diff options
Diffstat (limited to 'manual/rockbox_interface')
-rw-r--r-- | manual/rockbox_interface/main.tex | 29 |
1 files changed, 14 insertions, 15 deletions
diff --git a/manual/rockbox_interface/main.tex b/manual/rockbox_interface/main.tex index c637268fa2..c4b9e35835 100644 --- a/manual/rockbox_interface/main.tex +++ b/manual/rockbox_interface/main.tex | |||
@@ -12,37 +12,36 @@ | |||
12 | 12 | ||
13 | \end{center} | 13 | \end{center} |
14 | 14 | ||
15 | Throughout this manual, the buttons on the \dap{} are labelled according to the | 15 | Throughout this manual, the buttons on the \dap{} are labeled according to the |
16 | picture above. When a table of button actions says ``Long'' before the button it | 16 | picture above. Whenever a button name is prefixed by ``Long'', a long press of |
17 | means that you should make a long press on that button, in other words, press it | 17 | approximately one second should be performed on that button. The buttons are |
18 | for approximately 1 second. In detail the buttons are described in the following | 18 | described in detail in the following paragraph. |
19 | paragraph. | ||
20 | 19 | ||
21 | \blind{ | 20 | \blind{ |
22 | Additional information is available for blind users on the Rockbox website at | 21 | Additional information for blind users is available on the Rockbox website at |
23 | \wikilink{BlindFAQ}. | 22 | \wikilink{BlindFAQ}. |
24 | 23 | ||
25 | % | 24 | % |
26 | \opt{h1xx}{ | 25 | \opt{h1xx}{ |
27 | If you lay the \dap{} on the table with the joystick pointing | 26 | If you put the \dap{} on a table with the joystick pointing |
28 | towards you, and the curved sides at the top, you will find the following | 27 | towards you, and the curved sides at the top, you will find the following |
29 | if you start from the top-right corner and follow the side of the \dap{} in a | 28 | if you start from the top-right corner and follow the side of the \dap{} in a |
30 | clockwise direction: | 29 | clockwise direction: |
31 | On the right side the buttons \ButtonOn{}, \ButtonOff{}, \ButtonMode{} and | 30 | On the right side the buttons \ButtonOn{}, \ButtonOff{}, \ButtonMode{} and |
32 | the \ButtonHold{} switch. Next comes on the bottom the USB port, | 31 | the \ButtonHold{} switch. Next comes the USB port on the bottom, |
33 | a small hole for resetting the \dap{}, charger plug. On the left side located | 32 | a small hole for resetting the \dap{}, then the charger plug. On the left |
34 | is the button \ButtonRec{}. At least the top has headphone mini-jack plug, | 33 | side is the \ButtonRec{} button. The top has a headphone mini-jack plug, |
35 | remote port, optical/line in and optical/line out. | 34 | remote port, optical/line in and optical/line out connectors. |
36 | The joystick in the middle of the \dap{} is | 35 | The joystick in the middle of the \dap{} is |
37 | used to navigate menus by pressing it up, down, left and right. Pressing the | 36 | used to navigate menus by pressing it up, down, left and right. Pressing the |
38 | joystick down is labelled \ButtonSelect{} throughout this manual. Its | 37 | joystick button is labeled \ButtonSelect{} throughout this manual. Its |
39 | directions are labelled \ButtonRight{}, \ButtonDown{}, \ButtonLeft{} and | 38 | directions are labelled \ButtonRight{}, \ButtonDown{}, \ButtonLeft{} and |
40 | \ButtonUp{}. | 39 | \ButtonUp{}. |
41 | 40 | ||
42 | The internal microphone is located on the left hand side of the nit towards the | 41 | The internal microphone is located on the left hand side of the nit towards the |
43 | top, and there is a small reset hole on the bottom of the unit between the | 42 | top. As mentioned, there is a small hole on the bottom of the unit |
44 | power and USB sockets. To perform a hard reset, insert a paperclip into this | 43 | between the power and USB sockets. You can hard-reset the device by inserting |
45 | hole.} | 44 | a paperclip into this hole.} |
46 | % | 45 | % |
47 | \opt{h300}{ | 46 | \opt{h300}{ |
48 | Hold or lay the \dap{} so that the side with the button pad and | 47 | Hold or lay the \dap{} so that the side with the button pad and |